Sorry Arden, but that is not the problem. With a MSD you do not need
the ballast resistor, but with conventional system, you do or you will
burn up the points, etc. The MSD6 has no limit on engine speed, while
the 6AL has a chip for set engine speed.
One day left.
Larry
Arden Bedell wrote:
> Larry,
>
> I took a look at the MSD 6AL installation instructions, and it looks like
> there's a procedure for hooking it back up after it's been disconnected.
> This makes me wonder if the rev limit RPM was inadvertently reset to the
> factory default (low) and had to be reprogrammed after the starter
> installation was done.
>
> --Arden
>
#################################################################
#################################################################
#################################################################
#####
#####
#####
#################################################################
#################################################################
#################################################################
|