Thomas
I think that I agree with Rich on this. It is not easy to make precise
measurement but I make the distance between the appropriate holes on a
pair of H4s as 6" +- 1/32". The same measurement on a pair of H6s is 5
13/16" +- 1/32" so the difference is about 3/16" or a maximum of 1/4".
Filing 1/8" out of each end with a round file is straight forward. I
have done this a few times and it is easy.
regards
>Rich,
>
>no that's not the case (as far as I see it-enlightenment very welcome). The
>angle of the bracket has to be changed as well. Doing this, you have to cut
>the bracket were the abutment pin (the pin that fixes the outer control cable
>to the bracket) goes through the bracket.
>
>
>Thomas
>
>
>-----Urspr|ngliche Nachricht-----
>Von: Rich Chrysler [mailto:richchrysler at quickclic.net]
>Gesendet: Montag, 1. August 2011 14:28
>An: Thomas Willig
>Cc: healeys at autox.team.net
>Betreff: RE: [Healeys] Looking for 100M Choke abutment bracket
>
>Thomas,
>
>I was under the impression it is the same bracket but the end mounting holes
>are opened up a bit to fit the H6 setup.
>
>Rich
>
>-----Original Message-----
>From: healeys-bounces at autox.team.net [mailto:healeys-bounces at
>autox.team.net]
>On Behalf Of Thomas Willig
>Sent: 2011-08-01 4:03
>To: healeys at autox.team.net
>Subject: [Healeys] Looking for 100M Choke abutment bracket
>
>Hello,
>
>
>
>can someone enlighten me were I can get a choke abutment bracket for the
>100M? I am talking about the small steel strip of flat steel that goes
>over the entire opening between the two H6 carbs and is held there by
>the two bolts for the cold air box. The dimensions of this bracket
>differ from the one used for the standard h4 setup.
>Regards
>
>
>Thomas Willig
>_______________________________________________
>_______________________________________________
>Healeys at autox.team.net
>Donate: http://www.team.net/donate.html
>Suggested annual donation $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/ah at jharper.demon.co.uk
--
John Harper
|