Thomas -
Sounds too complicated! I just opened up the holes a bit like Rich
said, that was all I needed. Fit right up. I eventually switched
back again (I like the plain jane cars)..
Alan
On 8/1/11, Thomas Willig <twillig at ruda.de> wrote:
> Rich,
>
> no that's not the case (as far as I see it-enlightenment very welcome). The
> angle of the bracket has to be changed as well. Doing this, you have to cut
> the bracket were the abutment pin (the pin that fixes the outer control
> cable
> to the bracket) goes through the bracket.
>
>
> Thomas
>
>
> -----Urspr|ngliche Nachricht-----
> Von: Rich Chrysler [mailto:richchrysler at quickclic.net]
> Gesendet: Montag, 1. August 2011 14:28
> An: Thomas Willig
> Cc: healeys at autox.team.net
> Betreff: RE: [Healeys] Looking for 100M Choke abutment bracket
>
> Thomas,
>
> I was under the impression it is the same bracket but the end mounting holes
> are opened up a bit to fit the H6 setup.
>
> Rich
>
> -----Original Message-----
> From: healeys-bounces at autox.team.net [mailto:healeys-bounces at
> autox.team.net]
> On Behalf Of Thomas Willig
> Sent: 2011-08-01 4:03
> To: healeys at autox.team.net
> Subject: [Healeys] Looking for 100M Choke abutment bracket
>
> Hello,
>
>
>
> can someone enlighten me were I can get a choke abutment bracket for the
> 100M? I am talking about the small steel strip of flat steel that goes
> over the entire opening between the two H6 carbs and is held there by
> the two bolts for the cold air box. The dimensions of this bracket
> differ from the one used for the standard h4 setup.
> Regards
>
>
> Thomas Willig
> _______________________________________________
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/healey.nut at gmail.com
>
--
Sent from my mobile device
|