After checking out the bracket one more time, I can confirm that
enlarging the holes is the way to go. I should have known this... My
thinking was far too sophisticated J
Regards
Thomas Willig
Von: Tadeusz Malkiewicz [mailto:tadeusz.malkiewicz at gmail.com]
Gesendet: Montag, 1. August 2011 16:37
An: 'Rich Chrysler'; healeys at autox.team.net; Thomas Willig
Betreff: Re: [Healeys] Looking for 100M Choke abutment bracket
Thomas,
I believe Rich is correct.
I researched the M setup a bit when installing it on my car, and I
fitted the same bracket enlarging the holes.
Also, there was no extra bracket in LeMans kit, AFAIK.
Tadek
Message: 11
Date: Mon, 1 Aug 2011 14:49:14 +0200
From: "Thomas Willig" <twillig at ruda.de>
To: "Rich Chrysler" <richchrysler at quickclic.net>
Cc: healeys at autox.team.net
Subject: Re: [Healeys] Looking for 100M Choke abutment bracket
Rich,
no that's not the case (as far as I see it-enlightenment very welcome).
The angle of the bracket has to be changed as well. Doing this, you have
to cut the bracket were the abutment pin (the pin that fixes the outer
control cable to the bracket) goes through the bracket.
Thomas
|