Rich,
no that's not the case (as far as I see it-enlightenment very welcome). The
angle of the bracket has to be changed as well. Doing this, you have to cut
the bracket were the abutment pin (the pin that fixes the outer control cable
to the bracket) goes through the bracket.
Thomas
-----Urspr|ngliche Nachricht-----
Von: Rich Chrysler [mailto:richchrysler@quickclic.net]
Gesendet: Montag, 1. August 2011 14:28
An: Thomas Willig
Cc: healeys@autox.team.net
Betreff: RE: [Healeys] Looking for 100M Choke abutment bracket
Thomas,
I was under the impression it is the same bracket but the end mounting holes
are opened up a bit to fit the H6 setup.
Rich
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Thomas Willig
Sent: 2011-08-01 4:03
To: healeys@autox.team.net
Subject: [Healeys] Looking for 100M Choke abutment bracket
Hello,
can someone enlighten me were I can get a choke abutment bracket for the
100M? I am talking about the small steel strip of flat steel that goes
over the entire opening between the two H6 carbs and is held there by
the two bolts for the cold air box. The dimensions of this bracket
differ from the one used for the standard h4 setup.
Regards
Thomas Willig
_______________________________________________
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|