Thomas,
I was under the impression it is the same bracket but the end mounting holes
are opened up a bit to fit the H6 setup.
Rich
-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at
autox.team.net]
On Behalf Of Thomas Willig
Sent: 2011-08-01 4:03
To: healeys at autox.team.net
Subject: [Healeys] Looking for 100M Choke abutment bracket
Hello,
can someone enlighten me were I can get a choke abutment bracket for the
100M? I am talking about the small steel strip of flat steel that goes
over the entire opening between the two H6 carbs and is held there by
the two bolts for the cold air box. The dimensions of this bracket
differ from the one used for the standard h4 setup.
Regards
Thomas Willig
_______________________________________________
|