The evapo-rust works but it is REAL slow. Smells like another rust
remover I used and works the same way. It needs to stay immersed in
the fluid. Others have taken a water fountain pump and had it pump
the fluid over bits for many hours..
Lester
On Apr 9, 2009, at 9:20 PM, <corvallis@peoplepc.com> <corvallis@peoplepc.com
> wrote:
> I would not use a torch on lights and other things that might be
> plated or
> thin. Soaking it is best, and time. There is a whole range of
> liquids and
> everyone has their favorite. Just start with something and take your
> time. I
> sometimes will cut a nut off of a threaded shaft with a fine Dermal
> cutting
> wheel.
> I wonder if the http://www.evapo-rust.com/ would be of use? ...bill
> in
> oregon
> ==========================================================
> -----Original Message-----
> From: spridgets-bounces@autox.team.net
> [mailto:spridgets-bounces@autox.team.net] On Behalf Of Andrew Payne
> Sent: Thursday, April 09, 2009 6:57 PM
> To: 'Spridgets'
> Subject: [Spridgets] rusty bits
>
> I have been removing parts, with much frustration. Several parts
> have come
> off only with the use of my 24 tooth per inch "screw driver". WD-40
> is not
> enough. Any suggestions on techniques to free rusty screws and
> bolts? I
> have heard to use a blow torch, but was afraid to use one on lights
> and
> such. Please help, I am tired of the hacksaw.
>
> Drew
> _______________________________________________
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as oldsaabguy@comcast.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|