I would not use a torch on lights and other things that might be plated or
thin. Soaking it is best, and time. There is a whole range of liquids and
everyone has their favorite. Just start with something and take your time. I
sometimes will cut a nut off of a threaded shaft with a fine Dermal cutting
wheel.
I wonder if the http://www.evapo-rust.com/ would be of use? ...bill in
oregon
==========================================================
-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Andrew Payne
Sent: Thursday, April 09, 2009 6:57 PM
To: 'Spridgets'
Subject: [Spridgets] rusty bits
I have been removing parts, with much frustration. Several parts have come
off only with the use of my 24 tooth per inch "screw driver". WD-40 is not
enough. Any suggestions on techniques to free rusty screws and bolts? I
have heard to use a blow torch, but was afraid to use one on lights and
such. Please help, I am tired of the hacksaw.
Drew
_______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|