TABC is the TA, TB, TC. they have a news group similar to this one.
On the early T types the cross shaft is located by 2 very thin bronze
bearings that are in a cage and bolted to the chassis by two bolts each. The
bearing slips over the outside of the cross shaft. Since I have both cross
shafts, I'll look to see if it is possible to use the T type bearings on my P
type cross shaft. Others may have already done this and may already know the
answer.
Cheers
Dennis
PA1518
TA1679
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|