I don't know about that pump but a 12 gauge wire will carry 9.3 amps
(http://www.powerstream.com/Wire_Size.htm)... quite a but of electricity
Greg Schroeder wrote:
> I had replaced my original pump with a Viair 325. I also installed an inline
> fuse. If the tank is empty and I try to pump it up I am blowing the fuse and
> the wire is getting hot. I feel I need to use a thicker wire with this pump
> as compared to the other one since the amp draw appears to be higher. I could
> not find any information on Viair site, but found a install kit with a 12
> gauge wire. What would someone recommend for a replacement wire and inline
> fuse amperage.
>
> Greg 0036
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Bricklin@autox.team.net
> http://autox.team.net/mailman/listinfo/bricklin
>
> You are subscribed as mike.walsh@walshware.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Bricklin@autox.team.net
http://autox.team.net/mailman/listinfo/bricklin
http://www.team.net/archive
|