I would also run a relay in line, switch the relay with the pressure switch
so that it takes the electrical load off the pressure switch, for the feed
lines I always use 10 gauge minimum.
On 11/10/2009 7:12:00 PM, Greg Schroeder (gschroeder@comcast.net) wrote:
> I had replaced my original pump with a Viair 325. I also installed an
> inline
> fuse. If the tank is empty and I try to pump it up I am blowing the fuse
> and
> the wire is getting hot. I feel I need to use a thicker wire with this
> pump
> as compared to the other one since the amp draw appears to be higher. I
> could
> not find any information on Viair site, but found a install kit with a 12
> gauge wire. What would someone recommend for a replacement wire and
> inline
> fuse amperage.
>
> Greg 0036
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Bricklin@autox.team.net
> http://autox.team.net/mailman/listinfo/bricklin
>
> You are subscribed as rick@hightechcoatings.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Bricklin@autox.team.net
http://autox.team.net/mailman/listinfo/bricklin
http://www.team.net/archive
|