Around here in Illinois, AZ will only read cars with the OBDII. And it there
is no SES light on the GEN 3 there is nothing to read.
Paul
On 7/6/2006 10:41:28 AM, clubairth@bellsouth.net wrote:
> Steven:
> This is NOT correct. Codes stored in the PCM will be read, regardless if
> the
> check engine light is on or not. Be sure and get the actual code number.
>
> Also have the AutoZone guy erase ALL existing codes after he reads what
> you
> have. I NEVER change or troubleshoot until the code is repeated at
> least
> twice! Drive until the check engine light comes on again and then get
> the
> codes reread.
> Then post back to the list.
>
> I would recommend that you DO NOT take the car to a dealer. They were
> clueless when the SHO was new and
> it's only worse now that the SHO has been
> gone so many years!!!!
> .
> .
>
>
>
> >I called them and they said they can only scan for codes if the check
> >engine light stays on (which mine does not)
> >
> >
> > On Jul 5, 2006, at 6:06 PM, Ian Fisher wrote:
> >
> >> If you have an AutoZone near you, go there first.
> >> They'll
> scan for Diagnostic Trouble Codes for free.
> >> The dealer will charge you 1 hour of labor at
> >> $75ish/hour just to scan the codes. You can buy a code
> >> scanner for a lot less and do it yourself at home.
> >>
> >> Ian
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|