Mark,
Mark,
Hi there! Not too sure what you mean - I've taken the bolts out. Don't
think 3/8" tubing would go over the end of the con rods.
Regards, Adrian =
Message text written by Mark Moburg
>Adrian: RIGHT NOW before you do anything else, go get some rubber hose
(about 3/8 in I.D.), cut 8 pieces about 1-1/2 inches long, and slide them=
over the bolt ends on your rods. What you do not want to have happen is =
to
have one of those rod bolts ding a crank throw on the exposed bearing
running surface. If this happens, you're going to have to have the crank=
reground. ANY visible inperfection where the bearings run must be remove=
d
by turning the crank.<
|