Vince,
Wow! Good job you mentioned that!! I had marked the caps from where the=
y
had come from (ie # 1 and 4) but I was only 70% sure about their end to e=
nd
orientation. Fortunately, MOWOG, the God of Pain, smiled on his humble
servant and pointed out that the con rod ends are slightly different - on=
e
is squarish and the other is definitely rounded - this difference is
"impressed" on the caps. So now i know for certain which way round they
go. (I had them right in the first place but now I'm a 100% certain)
Thanks, pal Adrian
Message text written by "Vince J. Pujalte"
>Before you proceed any further, make SURE that you index each of the =
bearing caps so that they go on =
(1) the same bearings they came off of, AND =
(2) in the same end-to-end orientation.
Swapping a bearing cap end-to-end or installing on the wrong place in =
the block is a big no-no.<
|