> 1. The pins for the front of the springs are new, however the eyes are
worn
> (to varying degrees). as the eyes were probably never true, how good a fit
> should they be? Do people get the eyes relieved and put in bushes?
They need to be a nice snug fit or you will wear out a nice new pair of pins
quickly. I really like all 4 springs to be new as it really makes for a nice
firm ride. However, if you like the originals I would have the eys bushed.
I've seen this done and it works. Keep in mind, though, that it might not be
a real kool fit up as the eye is a sprung loop rather than a solid chunk of
metal being bored out. It may give a bit.
> 2. The fellow who did the chassis put in brass trunnions. Anyone have
> experience of this. (I was planning to put in phosphor bronze, but if the
> opinion is that they are Ok then I will keep them).
Bronze is certainly preferred for bushings but the brass should last for a
while. I looked up the alloy breakdown comparing brass and bronze last week
(for the same reason) and there really isn't that much difference.
Professional bushing people may differ!
> 3. As there is no shoulder on the pin of the rear springs, how does one do
up
> the nut as there is nothing to tighten it up to without clamping the
spring?
There is a hardened spacer INSIDE the spring and against the big shoulder
on the pin. It is shaped like a smaller version of the front spindle spacer
inside the inner bearing. Outside the spring is another heavy spacer, like a
1/4" washer, hardened.
>
> Thanks
>
>
> Andrew
>
> /// unsubscribe/change address requests to majordomo@autox.team.net or
try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|