buick-rover-v8
[Top] [All Lists]

RE: P76 V8 seals, gaskets, pumps, misc oil leaks

To: "'Peter Kent'" <pkent@skynet.net.au>,
Subject: RE: P76 V8 seals, gaskets, pumps, misc oil leaks
From: Simon Sparrow <Simon.Sparrow@wang.co.nz>
Date: Fri, 3 Sep 1999 09:32:08 +1200
Hi Peter,

How are the various projects going?

Does the SDI front cover work with the P76 pulley? Does the P5B pulley fit
the front of the P76 crank? What sort of oil pressure do you get with this
setup?

If I ever get round to doing a camshaft swap I'd like to put on a SDI front
cover as the water pumps are still available new - P76 ones are not.

Simon

-----Original Message-----
From: Peter Kent [mailto:pkent@skynet.net.au]
Sent: Thursday, 2 September 1999 20:14
To: Damien Haas; buick-rover-v8@autox.team.net
Subject: Re: P76 V8 seals, gaskets, pumps, misc oil leaks


You wrote:
So I began doing a little oil leak plugging and was looking at the
timing case on my P76 V8 and got to wondering.  Have any listers used
Rover 3.5 parts or Buick/Holden V6 parts on the P76 V8 ?
Reply:
We used the Rover P5B water pump with a Rover SD1 timing case on a P76 
engine in a Rover P5B. The advantage of the SD1 timing case is that it 
has a neoprene front oil seal that is less prone to leaking than the P5B 
rope oil seal, and it also has a higher volume oil pump. I had been told 
that the SD1 oil seal was slightly under-size for the P5B front pulley we 
used but measuring it didn't reveal a significant difference and it seems 
to have worked well in practise. One advantage in using Rover water pump 
and timing case is that the radiator inlet and outlet pipes are 
orientated in the right direction for the P5B radiator tanks. This may 
not suit you if the P76 engine is still in a P76 car, also I don't know 
if you can use a P76 water pump on a Rover timing case. 
The SD1 timing case has the petrol pump drive aperture blanked off, as 
the SD1 uses an electric fuel pump. We opted for an aftermarket electric 
fuel pump, both to aid starting and in anticipation of a future LPG 
conversion (which would not require a fuel pump). The SD1 oil pump drive 
has a different distributor end than the P5B. At first we had the P5B oil 
pump drive pressed into the SD1 oil pump gear, but it was too short to 
engage the bottom of the distributor. Rob Stewart Engineering made a 
longer oil pump drive ($40) with the appropriate end and it works well. I 
don't know how this would suit a P76 distributor.

You wrote:
The original Leyland head gaskets are tin. Is there a composition one
available apart from Repco ? Would rover 3.5 or maybe even 3.9, 4.6 or
4.9 head gaskets fit ?  
Reply.
Rover 3.5 composite head gaskets fit perfectly.

p.s. I have replaced the P76 rear main seal twice & it continues to leak.

<Prev in Thread] Current Thread [Next in Thread>