Search String: Display: Description: Sort:

Results:

References: [ +from:ghobers@sympatico.ca: 10 ]

Total 10 documents matching your query.

1. Re: Door Sill Question & Thanks too (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Sat, 18 Feb 2006 16:19:30 -0500
One is an expensive replacement part the other is how someone fixed his with sheet metal. George Hobers 69 2000 sent front sill? hear attempting replaced the Baseline
/html/datsun-roadsters/2006-02/msg00164.html (8,904 bytes)

2. Re: What Roadster part to make next? (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Sun, 26 Feb 2006 10:48:52 -0500
High windshield weatherstrips. George Hobers 69 2000 -- Original Message -- From: "Eric Hankinson" <eric@railpros.com> To: <datsun-roadsters@autox.team.net> Sent: Saturday, February 25, 2006 3:28 PM
/html/datsun-roadsters/2006-02/msg00203.html (7,645 bytes)

3. Roadster Recognition (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Wed, 5 Oct 2005 21:44:47 -0400
Just saw a Nissan advertisement in Motor Trend praising it's racing success past and present. The first car they mention is the Fairlady Roadster. They even have a small photo of a red roadster with
/html/datsun-roadsters/2005-10/msg00067.html (6,635 bytes)

4. Re: Fuel Sending Unit (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Sat, 27 Nov 2004 13:45:34 -0500
I just measured my new sending unit, never installed and I get 10 ohms full and 81 empty. Anywhere in between my hand isn't steady enough to get an accurate reading. This is for my 69 2000 and read a
/html/datsun-roadsters/2004-11/msg00336.html (7,318 bytes)

5. Re: Clutch install question (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Fri, 1 Oct 2004 22:12:40 -0400
Do not put grease on the raised part of the bearing. Lightly grease the splines on the input shaft then run the disc up and down the shaft then wipe the grease off so all you have left is a very ligh
/html/datsun-roadsters/2004-10/msg00012.html (9,408 bytes)

6. Re: Best way to make sure U20 is at top dead center.. (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Mon, 25 Oct 2004 23:07:33 -0400
To find TDC cyl. #1 remove all spark plugs. Now manually turn the crank clockwise with a socket and ratchet. When you get a quarter turn away from the timing marks put your thumb over cyl. #1. If it
/html/datsun-roadsters/2004-10/msg00368.html (8,232 bytes)

7. Re: windshield corner rust problem 69 2000 (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Tue, 26 Oct 2004 19:12:44 -0400
This link will send you to a place down under that sells 311 reproduction sheet metal. They have a patch panel for what I think you are looking for. George Hobers 69 2000 -- Original Message -- From
/html/datsun-roadsters/2004-10/msg00380.html (7,637 bytes)

8. Re: (OT) Maxima computer chip key (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Sat, 30 Oct 2004 11:11:49 -0400
Only a dealer can reprogram a key for you. That adds to the security of the immobiliser system. I have programmed aftermarket keys. You must have all keys you plan on using present when it's done bec
/html/datsun-roadsters/2004-10/msg00432.html (7,704 bytes)

9. Re: O/T '88 Nissan pickup question (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Fri, 26 Mar 2004 23:32:20 -0500
friend who has a '84 and is looking at buying an '88 and they both have the same problem. They drive fine until you accelerate hard and then they start cutting out. Almost like the injectors stop giv
/html/datsun-roadsters/2004-03/msg00469.html (8,307 bytes)

10. Gas tank straps (score: 1)
Author: "George Hobers" <ghobers@sympatico.ca>
Date: Thu, 31 Aug 2006 22:55:59 -0400
Any one have gas tank straps for sale for a low windshield 1600 or 2000. Thanks George
/html/datsun-roadsters/2006-08/msg00328.html (6,328 bytes)


This search system is powered by Namazu