http://www.hrc-dat.com.au/sub9.htm
This link will send you to a place down under that sells 311 reproduction
sheet metal. They have a patch panel for what I think you are looking for.
George Hobers
69 2000
----- Original Message -----
From: "Ron Mistak" <remfender@earthlink.net>
To: "datsun-roadsters@autox.team.net" <datsun-roadsters@Autox.Team.Net>
Sent: Tuesday, October 26, 2004 3:01 PM
Subject: windshield corner rust problem 69 2000
> Hello all again,
>
> i am sure some of you have fixed this problem on the later models,?????
> after you remove a late model windshield and check the frame, the bottom
> corners of the frame have a hole where water tends to seep down through
the
> gasket into the frame factory welded support and remains there to rust.
>
> both of my cars had this problem , some not as bad,, what is the best
> permanent fix,,
> just seal the frame corner for good????
>
> thanks
> Ron Mistak
|