I had a similar situation with my TR3 in 1972. The studs holding on the wire
wheel adapter broke. I head a bump and then the tire rolled past me going down
the road.
Ronald Olds
----- Original Message -----
From: Don Hiscock <don.hiscock@gmail.com>
To: Philip Ethier <pethier7@gmail.com>
Cc: Triumphs <triumphs@autox.team.net>
Sent: Mon, 27 Feb 2023 19:21:03 -0500 (EST)
Subject: Re: [TR] Is this symptom I'm getting indicative of a bad front
wheel bearing?
And I lost a front wheel on my TR3B at 70 mph on I-70 in 2014. I've not
quite gotten over that episode yet, Yes, don't fool around with wheel
bearings!
The root cause of my wheel-fell-off episode was a restorer who was more
used to MG bearing preloads than a TR3's non-preloaded bearings. He read
this part of the Red Book service instructions as 101 lb·ft, not 10 lb·ft.
Yikes.
https://photos.smugmug.com/photos/i-7mHq3MK/0/07d96589/O/i-7mHq3MK.png
https://photos.smugmug.com/photos/i-8zPPqt3/0/1e459484/XL/i-8zPPqt3-XL.jpg
https://photos.smugmug.com/photos/i-wBTPGjg/0/5123f2e5/X3/i-wBTPGjg-X3.jpg
This happened in western Ohio, not too far from Macy's Garage as it turned
out. And although Mark and Co. didn't do the work that led to the wheel
coming off, they know my car and were able to take it into their shop that
afternoon while I flew home.
So listen to the voice of two of us with scary experiences. Take care with
wheel bearings.
On Mon, Feb 27, 2023 at 6:01 PM Philip Ethier <pethier7@gmail.com> wrote:
> Don't mess with wheel bearings. Get it checked out. I lost a wheel
on my
> TR4 on the way home from the VTR in 2005.
>
> On Mon, Feb 27, 2023 at 5:35â?¯PM Sujit Roy <triumphstag@gmail.com>
wrote:
>
>> I have a Stag and have checked and changed various components like
bottom
>> ball joint and top shock mount, but am still experiencing a vibration,
>> through the steering wheel, from the left front wheel only when
I'm
>> turning left. The car had been fitted with all new poly bushes.
>> There is no vibration going straight or when turning right.
>> I plan to swap the wheel with my spare, but can a bad bearing cause
>> these symptoms?
>> The hub rotates smoothly and there is no noise.
>>
>> The TR6 uses a similar vertical link setup as the Stag. The hub
>> bearings are tapered.
>>
>>
>> Sujit
>>
>> --
>> Sujit Roy
>> Cupertino, California
>>
>> https://triumphstagblog.wordpress.com/
>>
>> ** triumphs@autox.team.net **
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/pipermail/triumphs
>> http://www.team.net/archive
>>
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/triumphs/pethier7@gmail.com
>>
>
>
> --
> Phil Ethier West Side Saint Paul Minnesota USA
> 1973 Triumph Stag LE22439UBW "uncle jack", Sapphire Blue
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs
> http://www.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/don.hiscock@gmail.com
>
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|
