triumphs
[Top] [All Lists]

Re: Dist. Vac. Line

To: Geo Hahn <ahwahnee@cybertrails.com>
Subject: Re: Dist. Vac. Line
From: Bob Labuz <yellowtr@adelphia.net>
Date: Fri, 8 Apr 2005 22:22:33 -0500
On Thursday 07 April 2005 05:27 pm, Geo Hahn wrote:
> Bill & Skip Pugh wrote:
> >     The Distributor vacuum  line  has  broken  ... again ... very near
> > the bottom of the Carb.  I am pretty sure this is due to old metal,
> > and some slight engine vibration over time (well OK a LOT of engine
> > vibration) ...
>
> Has you line been secured at the thermostat housing?  If not, this may
> significantly reduce the vibration.  I think (but am not sure) that the
> clip and rubber fitting for the fuel and vacuum lines are once again
> available.
>
> Geo Hahn

List,

Moss also sells the clip and rubber fitting. Very cheap! I have them installed 
on my TR3A and as I said earlier and it has the original line.

Bob Labuz

1958 TR3A
1963 TR4
1974 T140V
1998 T-Bird T-3




<Prev in Thread] Current Thread [Next in Thread>