I do'no. I just put the TR3 lever on the TR4 gearbox and drove away.
I've never had any problems with an unmodified TR3 lever.
Jim Wallace wrote:
> I'm putting a TR4a gearbox into my TR3a, and want to use the 3a shift
> lever.
> Just noticed, the bottom of the 4a shift lever, where it engages the
> selector rods, is tapered, whereas the bottom of the 3a lever is square.
> Should I grind the bottom of the 3a shift lever so it matches the 4a
> lever? Was this an improvement for smoother shifting or less wear on the
> selector rods perhaps?
|