Hi Mark
I always remove the nut, remove the washer then replace the nut, when the
whole lot goes bang as the joint separates the nut stops the shaft and
flange going separate ways!
Graham.
----- Original Message -----
From: "Mark Gendron"
Subject: RE: How do you remove !@#^%$ rear hubs
. Be sure to set up some padding
> underneath the press to catch the axle shaft
> when it pops out, so you don't damage the splines
> or the taper. Or your feet.
>
> -Mark
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.634 / Virus Database: 406 - Release Date: 19/03/2004
|