> -----Original Message-----
> 1967 TR4A solid axle -
>
> 1) How to you remove the blaster rear hubs.
> I need them off to put
> in new studs and change the seals & bearings.
In my experience, the best way to do this is to
remove the entire axle shaft along with the
hub, bearing, and housing. Then put the unit
on a hydraulic arbor press. It will take at least
a ton of pressure to remove, probably more.
You can help it by gently heating the hub with
a propane torch. Be sure to set up some padding
underneath the press to catch the axle shaft
when it pops out, so you don't damage the splines
or the taper. Or your feet.
-Mark
|