Sorry I should have been more specific... I do not need to make these holes
in my switch plinth. I need to make similar holes in steel and/or aluminum
sheet.
> From: Peter Zaborski
> Sent: Thursday, February 25, 1999 2:28 PM
>
> The TR6 (and others) has holes in the dash switch plinth for
> a variety of switches and control knobs. These switches and
> control knobs fit into the plinth via an almost round hole. I
> say almost because in order to properly orient the switch,
> the hole will be shaped like a plump D with the flat part of
> the hole matching up to a flat on the threaded shaft of the
> switch (ie. the heater switch, the choke control knob, the
> heat control knob, etc.).
>
> Does anyone have a technique for making such D shaped holes?
> (I don't have a metal lathe or any other such equipment, no
> CNC machine either).
>
> Thanks for any insights.
>
> --- Peter Zaborski CF58310UO ---
>
|