There have been some questions asked on the list that I wondered about in
the past and I suppose they may have got replies off the list. I thought I
would watch for the answer or help and maybe read and learn something. So I
have tried to Cc: the list for perhaps someone else may be interested in the
subject. Sure there are plenty of posts that bore me and others when that
don't have that certain problem at the present time. I suppose my last post
of address was not necessary. I wasn't thinking. Sorry.
-----Original Message-----
From: stu.jo@ibm.net <stu.jo@ibm.net>
To: Charlie <c2h60_@email.msn.com>
Date: Friday, November 13, 1998 3:52 PM
Subject: Re: Roll Pin
>Charlie wrote:
>>
>> I was so excited I forgot you may need my address. 42963 Southeast 170th
>> Court, North Bend WA 98045-9643. I'll send you a check for a couple a
>> bucks if you give me your address. Thanks again.
>> -----Original Message-----
>> From: Gambony, Jim <jim.gambony@eds.com>
>> To: 'Charles Ackerman' <C2H60_@email.msn.com>
>> Date: Thursday, November 12, 1998 9:31 PM
>> Subject: RE: Roll Pin
>>
>> >Charles,
>> >
>> >Good news and bad news.
>> >
>> >Good news: I picked up the pin for you today
>> >Bad news: it'll cost you $.35 ($.03 for the pin... and $.32 for postage
>> :-)
>> >
>> >That is if you still need it?
>> >
>> >Jim
>> >
>> >> -----Original Message-----
>> >> From: Charles Ackerman [SMTP:C2H60_@email.msn.com]
>> >> Sent: Thursday, October 22, 1998 7:17 PM
>> >> To: Gambony, Jim
>> >> Subject: Re: Roll Pin
>> >>
>> >> Hi Jim,
>> >>
>> >> 1/8 X 1-7/8
>> >>
>> >> CC51493LO
>> >> -----Original Message-----
>> >> From: Gambony, Jim <jim.gambony@eds.com>
>> >> To: 'Charles Ackerman' <C2H60_@email.msn.com>
>> >> Date: Thursday, October 22, 1998 1:18 PM
>> >> Subject: RE: Roll Pin
>> >>
>> >>
>> >> >Charles,
>> >> >
>> >> >Do you know the dimensions for the pin (diameter and length)?
>> >> >
>> >> >I found the local industrial supply house could supply some of the
"odd"
>> >> >sizes pretty well.
>> >> >
>> >> >Jim
>> >> >
>> >> >> -----Original Message-----
>> >> >> From: Charles Ackerman [SMTP:C2H60_@email.msn.com]
>> >> >> Sent: Thursday, October 22, 1998 2:35 PM
>> >> >> To: triumphs_list
>> >> >> Subject: Roll Pin
>> >> >>
>> >> >>
>> >> >> Howdy folks,
>> >> >> If anyone out there has the long roll pin for the gas door I will
buy
>> >> it.
>> >> >> Seems all the roll pins at NAPA etc. are to short. Thanks
>> >> >> CC51493LO
>> >> >>
>> >> >>
>> >>
>> >>
>Charlie, don't flame me, but I wonder why you copied the list on a
>personal message. Just more stuff to wade thru!Stu
|