I was so excited I forgot you may need my address. 42963 Southeast 170th
Court, North Bend WA 98045-9643. I'll send you a check for a couple a
bucks if you give me your address. Thanks again.
-----Original Message-----
From: Gambony, Jim <jim.gambony@eds.com>
To: 'Charles Ackerman' <C2H60_@email.msn.com>
Date: Thursday, November 12, 1998 9:31 PM
Subject: RE: Roll Pin
>Charles,
>
>Good news and bad news.
>
>Good news: I picked up the pin for you today
>Bad news: it'll cost you $.35 ($.03 for the pin... and $.32 for postage
:-)
>
>That is if you still need it?
>
>Jim
>
>> -----Original Message-----
>> From: Charles Ackerman [SMTP:C2H60_@email.msn.com]
>> Sent: Thursday, October 22, 1998 7:17 PM
>> To: Gambony, Jim
>> Subject: Re: Roll Pin
>>
>> Hi Jim,
>>
>> 1/8 X 1-7/8
>>
>> CC51493LO
>> -----Original Message-----
>> From: Gambony, Jim <jim.gambony@eds.com>
>> To: 'Charles Ackerman' <C2H60_@email.msn.com>
>> Date: Thursday, October 22, 1998 1:18 PM
>> Subject: RE: Roll Pin
>>
>>
>> >Charles,
>> >
>> >Do you know the dimensions for the pin (diameter and length)?
>> >
>> >I found the local industrial supply house could supply some of the "odd"
>> >sizes pretty well.
>> >
>> >Jim
>> >
>> >> -----Original Message-----
>> >> From: Charles Ackerman [SMTP:C2H60_@email.msn.com]
>> >> Sent: Thursday, October 22, 1998 2:35 PM
>> >> To: triumphs_list
>> >> Subject: Roll Pin
>> >>
>> >>
>> >> Howdy folks,
>> >> If anyone out there has the long roll pin for the gas door I will buy
>> it.
>> >> Seems all the roll pins at NAPA etc. are to short. Thanks
>> >> CC51493LO
>> >>
>> >>
>>
>>
|