DANMAS@aol.com wrote:
>
> In a message dated 97-10-31 07:19:40 EST, egil@kvaleberg.no writes:
>
> > On 31 Oct 1997, Joe Curry wrote:
> >
> > > One lead goes to the coil negative connection
> > > One goes to Ground
> > > The third goes to Power and the voltage stabilizer.
>
> To which Egil replied:
>
> > The trad. 70s Lucas electronic Tacho is connected in *series* with the
> > coil. So it requires that the connection between the coil and the points
> > is routed *via* the tach. So you need two wires for this. The standard
> > connectors at the tach are such that it is easy to connect them should you
>
> > ever need to remove the tach for servicing etc. Failing to do that will
> > cut the ignition if you remove the tach.
> >
> > In addition to these two wires, you need a supply and ground wire, as you
> > noted. Plus a wire to the instrument lighting, of course.
> >
> > > You always have theoption of an after-market one.
> >
> > They will usually connect as you have noted, with ONE wire to the coil.
>
> Egil:
>
> Lucas also supplied the type tachometer as described by Joe. The type you
> mentioned was used in MGBs, while the other type was used in Spitfires (at
> least in the later years).
>
> There is one error in what Joe said about connecting a tachometer that needs
> to be corrected. The tach should NOT be connected to the voltage stabilizer
> that supplies the other gauges. First of all, it is not required, as the tach
> has its own internal regulation. Secondly, the existing regulator is designed
> to provide the correct output voltage with a specific load, based on the
> gauges which were installed by the factory. Adding another gauge will change
> the output voltage, making the gauges read even less accurately than they
> already do. The voltage will be lower, making the gauges read less than they
> should.
>
> Dan Masters,
> Alcoa, TN
>
> '71 TR6---------3000mile/year driver, fully restored
> '71 TR6---------undergoing full restoration and Ford 5.0 V8 insertion - see:
> http://www.sky.net/~boballen/mg/Masters/
> '74 MGBGT---3000mile/year driver, original condition
> '68 MGBGT---organ donor for the '74
So what type was used in the TR8?I am switching distributors to a
Mallory dual point. Thanks, Stu
|