In a message dated 2/22/00 5:27:34 AM Pacific Standard Time,
ross-piercey@home.com writes:
> Just looked at the flanger on the Eastwood site and it does look kind of
> under powered with the short handles, where could I get the pneumatic
> tool you talked about. Btw I will butt weld the panels if it is the best
> way to go, but if a easier way is possible then, why not do it.
> thxs for the comments.
>
> Ross 51 Chevy 3/4 LB
This may have been mentioned in an earlier reply, but one advantage to butt
welding is that you leave no place for water/moisture, etc., to get in and
start rusting again. Butt welding may take more time fitting, but I think
it's worth it in the long run.
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|