Looking at page 42 in Clausager, it would seem that the original mounting
point would be far enough inboard of the top seal not to interfere (judging
from the line of lift-the-dot studs). Are you sure you have the seat belts
mounted to the correct location?
on 10/21/03 2:22 PM, David Councill at dcouncil@imt.net wrote:
> I managed to install my mounts to the tonneau panel area on my 72B as I
> believe it was designed. And that is fine with one problem. When the soft
> top is on, the mount keeps the top slightly raised at that point so I don't
> get a good rear seal on it. Anyone else have this problem? Do I need to
> move the mounts elsewhere?
>
> Maybe its no big deal, if I can get my hard top assembled. But for now, I
> really like the folding frame. Top up in the morning when its 50 degrees
> out but the top is off and in the low 80s this afternoon - very unusual for
> October in Montana.
>
> David Councill
> 67 BGT
> 72 B
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
|