It is far enough from the seal not to interfere directly. But it is raised
enough so although I can seal with the lift-the-dot studs, the top does not
seal flush with the body, leaving a small gap right behind where the seat
belt mount is. It maybe the seatbelt part, maybe its normal, hard to say
since I have no real reference point. Thats why I ask. Experience tells me
that when its below zero out, I want the tightest seal possible.
David
At 04:05 PM 10/21/2003 -0700, Max Heim wrote:
>Looking at page 42 in Clausager, it would seem that the original mounting
>point would be far enough inboard of the top seal not to interfere (judging
>from the line of lift-the-dot studs). Are you sure you have the seat belts
>mounted to the correct location?
|