I managed to install my mounts to the tonneau panel area on my 72B as I
believe it was designed. And that is fine with one problem. When the soft
top is on, the mount keeps the top slightly raised at that point so I don't
get a good rear seal on it. Anyone else have this problem? Do I need to
move the mounts elsewhere?
Maybe its no big deal, if I can get my hard top assembled. But for now, I
really like the folding frame. Top up in the morning when its 50 degrees
out but the top is off and in the low 80s this afternoon - very unusual for
October in Montana.
David Councill
67 BGT
72 B
At 04:35 PM 10/21/2003 +0100, Telewest wrote:
>Originally both GTs and roadsters had fixed belts bolted to the side of the
>arches (see Clausager). Then they were moved to the tonneau panel for North
>American MkIIs and other markets from 71 to 77, but the quick-release mounts
>for there are long gone. My 73 and 75 still have the arch side mounting
>points even though the 75 is a GT with inertia reels on top of the arches.
>Brackets are available to bolt 'standard' inertia reel units to the arches
>to my 73 roadster.
>
>PaulH.
|