> Bob if the carrier bearing and mounting rubber are ing good shape I don't
>think it would hurt to run slip yokes on either side or you can elimate the
>rear slip yoke if the rear suspension doesn't have much travel.
wmts
> From: Bob B <saltracer@shaw.ca>
> Date: 2003/04/16 Wed PM 12:17:23 CDT
> To: land-speed@autox.team.net
> Subject: drive shaft ? for chevy truck guys
>
> Looks like my camaro project car might be sold so looking what I will do.
>Looking at 70's chevy pick up as the motor and running gear from the camaro
>could go in there. My question is has anyone used a super T10 with a 2 piece
>drive shaft. How did you deal with the original having a bolt on trans yoke
>and the super t10 a slip only. Looks like the length is too long for a 1
>piece so any info would be great.
>
> Bob
>
> ///
"Sparky"
Lakester 2211
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|