In a message dated 4/16/03 5:16:29 PM Central Daylight Time,
lsr_man@yahoo.com writes:
<<
I'm going to try my hand at making a set of headers. Gas weld or mig?
Dick J in East Texas
>>
Too bad you don't have a tig set up which is what I would do. With what you
have I would mig the flange and gas weld the pipe. My dad was an artist with
a gas torch and it would look about like tig. He was an old pipe welder
before there was to much electric welding going on.
Larry Mac
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|