Dick,
I was told to mig the inside and the clean up with grinder--the to braze-solder
the outside joint using a 3/16 or 1/8 fluxed rod--ie use low heat small gas
tip, heat the flange and let the metal flow into the tube - flange joint
crack--if the metal bubbels you are using to much heat. wmts
>
>
"Sparky"
Lakester 2211
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|