But it might wear out the threads after several use.
I made a cleaning bolt once but I don't use it anymore.
I took a bolt and cut notches along the thread like on a tap.
I run the bolt into the hole and the in the notches the dirt is collected.
It is more easy on the threads than a tap.
But in my case gasket remover does it well.
-----Urspr|ngliche Nachricht-----
Von: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] Im
Auftrag von Mark Eginton
Gesendet: Freitag, 23. Juli 2010 03:21
An: fot@autox.team.net
Betreff: Re: [Fot] Flywheel Bolt Locking Plates
I just run a tap thru and Bob's your Uncle. No fuss no muss...
Grind off the tip of an old one for bottom end applications.
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/tr4racing@googlemail.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|