In terms of dimensions, you are right. But remember, they must be grade 8.
-----Original Message-----
From: 6pack-bounces+jar7u=hscmail.mcc.virginia.edu@autox.team.net on behalf of
Robert Lang
Sent: Wed 4/2/2008 11:56 AM
To: triumph@2simpleusa.com
Cc: 6pack@autox.team.net
Subject: Re: [6pack] Supplier of bad bolts
Hi,
Supposedly, there's a rod bolt available from Catapiller (I think) that's
a direct fit for TR6 rods. AND they are x-rayed for defects so you know
they are good.
I don't recall that the TR6 rod bolts are anything that unusual, 3/8" fine
thread... the shank underthe head is precision fit to the hollow locating
dowels, that's pretty much it. So, an off the shelf bolt (any grading)
would probably not work but there are other sources of bolts out there.
FWIW, I did a motor this weekend with the GoodParts replacement rod bolts.
Very nice. Def. reccommended.
regards,
rml
---------------------------------------------------------------------------
Bob Lang NER/SCCA | This space for rent
Solo Chair 2008 TR6 40 F Prepared | Triumph!
Voice:781-438-2568 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as jar7u@hscmail.mcc.virginia.edu
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|