Or if like me you don't have a compressor you fit a bicycle valve to a
spare master cylinder cap and use a bicycle pump!
In a message dated 10/05/2011 05:03:11 GMT Daylight Time,
dlh2001 at comcast.net writes:
One way to "power bleed" is to find a rubber stopper that fits tightly
over the master cylinder fill hole. You then drill a hole in the stopper
such that you can fit it to an air blow gun attachment.
Fire up the compressor and set the regulator to a few psi.
Check the master fluid level often as you proceed.
Worked for me.
|