No, I hadn't as it wasn't really my question ... but I tried it and look
what came up on sierra's site?
http://www.brakecylinder.com/sleeve2.htm#stainless
----Original Message Follows----
From: <corvallis@peoplepc.com>
To: "'Robert Duquette'" <robertduquette@sympatico.ca>
Subject: RE: [Spridgets] Sleeving master/brake cylinders - Stainless vs.
Brass
Date: Thu, 19 Jun 2008 06:27:23 -0700
Have you Googled the subject? There are other cars out there that have had
experience with this issue. ...bill in oregon
===========================================================================
----Original Message Follows----
From: "Dean Hedin" <dlh2001@comcast.net>
I am sure that the brass the outfits are using is durable but I can still
imagine corrosion and wear in brass after a couple years, especially in the
master
cylinder.
What I can't figure is why doesn't everybody use stainless? The material
cost is not the issue here.
_______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|