I'm debating the same thing right now. APT has it cheaper then MOSS. My
dilemma is that I have a Weber 45dcoe on the shelf and would need to re-jet
and re tune it plus add rams and filters. Or I stick with the Twin SU's and
just buy the Cast filter kit?
After reading Vizards section on Carbs and intake manifolds etc.. I'm not
sure If I'll gain much by going Weber.
Comments?
-----Original Message-----
From AHSprite78 at aol.com [mailto:AHSprite78@aol.com]
Sent: Tuesday, January 25, 2000 7:54 PM
To: spridgets@autox.team.net
Subject: K&N filter source
I'm looking in to getting a set of K&N's for my sprite. I've got 2 HS2's
(1.25 ") If I do go with them I'd like to use a set of ram pipes too.
So...
what I was wondering is where can I get a pair of K&N's that will fit over
the ram pipes? I've seen the setup that VB (or is it Moss) with the built
in
velocity stacks, but it's a little pricey for me, something like $150 I
think.
Thanks
Matt Smith
'67 Sprite
|