Kroyell@aol.com wrote:
>
> I am removing the interior panels on the 72 Midget to have them recovered and
> need some info. I ran out of time tonight and didn't have time to look it over
> very well but can't see any obvious way to remove the Bonnet release cable
> handle so I can remove the panel it is coming through.
> Anyone know the answer to this one to save me some time??
The quickest way (your not going to like this)
Remove engine and trans, undo nut on the back of the cable, undo cable
stop at bonnet, pull cable through panel.
Note, this is the quickest way.
Option #2: try to undo the nut on the back of the cable inside the trans
tunnel with tranny inplace (a magic wand will greatly help here or maybe
a Genie, Leprechaun, telekenisis) This is much easier but not
neccessarily faster then pulling the tranny.
Good luck
--
Frank Clarici
Toms River, NJ
Bugeye Sprite
67 Sprite
59 A40
http://www.exit109.com/~spritenut/
|