Frank Clarici wrote:
>
> The quickest way (your not going to like this)(to remove hood release cable)
> Remove engine and trans, undo nut on the back of the cable, undo cable
> stop at bonnet, pull cable through panel.
> Note, this is the quickest way.
> Option #2: try to undo the nut on the back of the cable inside the trans
> tunnel with tranny inplace (a magic wand will greatly help here or maybe
> a Genie, Leprechaun, telekenisis) This is much easier but not
> neccessarily faster then pulling the tranny.
>
> Good luck
>
> --
> Frank Clarici
> Toms River, NJ
> Bugeye Sprite
> 67 Sprite
> 59 A40
> http://www.exit109.com/~spritenut/
You said that right. Still going through that on a 69 Sprite. But
something I ran into was that the replacement knob (T handled) has a
larger diameter stock than the one I removed. Should I go ahead and
drill it out or did my supplier send me the wrong one?
Thanx Mark Snowdon,Greensboro NC
|