Mike,
The material is phosphor bronze. I sell these at #2.75 each (which is miles
cheaper than the dealers). They are 10 'thou oversize on the diameter
(which, in practice doesn't really matter because most housings have wear in
them).
JOHN JAMES (PB0722 & J3656)
-----Original Message-----
From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net] On
Behalf Of Mike Hughes
Sent: 14 November 2006 18:11
To: Bob Grunau; Lew Palmer; 'MG-MMM'
Subject: Re: PA rear spring front pivot
I recall always seeing them referred to as "bronze" or even "phosphor
bronze" trunnions. Can anyone verify this?
- Mike Hughes -t?t-
> I removed the rear trunnion brass slider blocks and of course they are
> quite worn. What is the recommended "brass" or any other material to make
> these trunnions? Is there a better material than solid brass?
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|