Hi Jim, I just looked at a spare TA and the hole looks to be 3/4 inch. It's
a cast in hole not drilled. Also if you decide to replace the TA keep in
mind the 4A TA's are different than the TR6 ones. I don't know if the 250
TA's are like the 4A or the 6's. The difference is in the bump stops
positions. TR6 are on the TA's and 4A's are on the body.
Trust this helps. Marv Gruber might have a good replacement. I've CC him on
this email.
-----Original Message-----
From: Jim Henningsen
Sent: Sunday, October 4, 2020 4:42 PM
To: triumphs@autox.team.net
Subject: [TR] TR4A IRS Rear Trailing Arm Issue
List:
I decided to take a break on my TR6 engine bay reinstall and work on the 67
TR4A IRS. After dissembling the drivers side rear suspension, I noticed the
hole in the rear of the arm for the shock link is wallowed out. What's the
correct diameter of the hole? I don't have a spare trailing arm to check
and any ideas on creative solution to fix it?
Thanks,
Jim Henningsen
Ocala, FL
61 TR3A
62 TR4
67 TR4A
75 TR6
81 TR8
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/jerryvv@roadrunner.com
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
|