triumphs
[Top] [All Lists]

[Fot] TR6 transmission rebuild - counter shaft gears

Subject: [Fot] TR6 transmission rebuild - counter shaft gears
From: van.mulders.marcel at telenet.be (van.mulders.marcel at telenet.be)
Date: Mon, 8 Jan 2018 19:20:21 +0100 (CET)
References: <4217F2D0-224C-4534-A59F-147459EEF066@icloud.com> <160d630d95c-171d-34881@webjas-vaa197.srv.aolmail.net>
These shell needle bearings are easily damaged : when the shell is warped a 
bit, it will fail. When the bearing is in place, one should check if the 
needles can be spinned freely. 
A nylaton bush of the TR4a -TR6 inner wishbone bearing is great for pushing 
these shell bearings in place. These bearings are not secured by a circlip, 
contrary to the open cage needle bearings. 
But the needles of the open cage bearings are running directly against the ev. 
worn or damaged inner surface of the laygear. 
Marcel 


Van: "fot" <fot at autox.team.net> 
Aan: gblake58tr3 at icloud.com, "fot" <fot at autox.team.net> 
Verzonden: Maandag 8 januari 2018 15:33:33 
Onderwerp: Re: [Fot] TR6 transmission rebuild - counter shaft gears 

It probably has the later type shell bearings and 1 or both have worked loose 
in the laygear housing bore and "milled" into the thrust washer (s). 
Glen 



-----Original Message----- 
From: Greg Blake via Fot <fot at autox.team.net> 
To: Fot <fot at autox.team.net> 
Sent: Sun, Jan 7, 2018 8:56 pm 
Subject: [Fot] TR6 transmission rebuild - counter shaft gears 

I am rebuilding a TR6 transmission and ran into a strange snag. When I removed 
the countershaft the counter shaft gears did not drop to the bottom of the 
case. I had to tap on the counter shaft gear set with a brass punch to get them 
to move far enough to allow the input shaft and gear to be removed. Now that I 
have the main shaft out of the case, I can't get the counter shaft gears out of 
the case. I've been able to move them a little bit by tapping on the gears with 
a brass punch through the drain hole but I can't get them out. Has anyone run 
into this before? Any ideas to get them out? 

Thanks. 

Greg 

Sent from my iPhone 
_______________________________________________ 
[ mailto:fot at autox.team.net | fot at autox.team.net ] 

[ http://www.fot-racing.com/ | http://www.fot-racing.com ] 

Archive: [ http://www.team.net/archive | http://www.team.net/archive ] 
Forums: [ http://www.team.net/forums | http://www.team.net/forums ] 



_______________________________________________ 
fot at autox.team.net 

http://www.fot-racing.com 

Archive: http://www.team.net/archive 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/fot/attachments/20180108/24b1f31b/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>