its a TR2 or TR3 diagram
the TR4 is similar but the dip switch is up on the turn indicator. is it not?
Frank
From: Wbeech <wbeech at flash.net>
To: "diggle at clear.net.nz" <diggle at clear.net.nz>
Cc: "triumphs at autox.team.net" <triumphs at autox.team.net>
Sent: Tuesday, December 20, 2011 11:44 AM
Subject: Re: [TR] Wiring loom
Frank Fisher may have a nice easy-to-read and complete diagram for your car. I
used his when replacing my tr3 wiring loom/harness and it was spot on.
Frank...?
Sent from mobile Bill
On Dec 20, 2011, at 1:32 PM, diggle at clear.net.nz wrote:
> Due to severe lack of budget I'm trying to do the extremely
> hard task of repairing my loom.
> The long term fix is to replace my loom.
> Unforetunately the PO has added metres and metres of extra
> wiring that either went nowhere or was attached to a bank of
> switches that did nothing.
> I have chopped out wiring that went nowhere and did nothing
> (I hope).
> I have downloaded dan master's beautifully colour coded
> diagram to ensure that I have not gone too far but I seem to
> have more small regulators than is listed. Is there a
> diagram which shows the actual wiring or is Dan's actually
> complete.
> Has anyone repaired then tested before putting their loom
> back and if yes is there a practicle way of doing it.
>
> Jim the the 1962 TR4
>
> ** triumphs at autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/wbeech at flash.net
** triumphs at autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/yellowtr3 at
yahoo.com
|