[TR] Wiring loom

[diggle at clear.net.nz (diggle at clear.net.nz)]

Due to severe lack of budget I'm trying to do the extremely
hard task of repairing my loom. 
The long term fix is to replace my loom.
Unforetunately the PO has added metres and metres of extra
wiring that either went nowhere or was attached to a bank of
switches that did nothing.
I have chopped out wiring that went nowhere and did nothing
(I hope). 
I have downloaded dan master's beautifully colour coded
diagram to ensure that I have not gone too far but I seem to
have more small regulators than is listed. Is there a
diagram which shows the actual wiring or is Dan's actually
complete.
Has anyone repaired then tested before putting their loom
back and if yes is there a practicle way of doing it.

Jim the the 1962 TR4