Not positive but will check that out. Thanks.
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Dave1massey@cs.com
Sent: Tuesday, October 20, 2009 8:20 AM
To: triumphs@autox.team.net
Subject: Re: [TR] Re-Tapping Threads
In a message dated 10/19/2009 9:34:44 PM Central Daylight Time,
suhringtr36@comcast.net writes:
> Can you re-tap threads using a smaller threads per inch tape? I have a
> screw
> hole that is a size #6 with 36 thread and I can only get a #6 screw with
> 32
> thread screw. Can I tap the 36 thread hole with a 32 tap and use the 32
> thread screw without messing up the threads? Hope this is clear....
>
Are you sure they are not metric? Have you tried an M4 with a .7 pitch?
Dave
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|