In a message dated 10/19/2009 9:34:44 PM Central Daylight Time,
suhringtr36@comcast.net writes:
> Can you re-tap threads using a smaller threads per inch tape? I have a
> screw
> hole that is a size #6 with 36 thread and I can only get a #6 screw with
> 32
> thread screw. Can I tap the 36 thread hole with a 32 tap and use the 32
> thread screw without messing up the threads? Hope this is clear....
>
Are you sure they are not metric? Have you tried an M4 with a .7 pitch?
Dave
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|