6-36 is not a standard screw size, so I would agree with Dave on this one.
Where is the tapped hole in question?
Mike
>>
> Are you sure they are not metric? Have you tried an M4 with a .7 pitch?
>
> Dave
> _______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|