On Saturday 27 December 2008 12:57:22 Alex wrote:
> Hey Bob,
> Ok, now I am still confused. Some facts I should have stated.
> 1. My 3 is a negative ground car.
Ok, then the white wire (ignition switch +) should go to the + coil
connection.
> 2. My Facet pump is only for negative ground cars.
They say this but since the pump is not grounded to the body it is either.
> 3. The black wire on the pump comes with an eye connector for grounding
> already on the black wire. The instructions show black as ground.
Black wire goes to ground in your case. Black = NEG. Negative ground.
> 4. The instructions indicate attaching the red to the newly installed oil
> pressure switch "P" terminal. (No oil pressure installed). Which indicates
> to me positive.
Yes the red will be your POWER or + connection and should be connected to the
switched ignition white wire coming off the harness and connected to the +
side of the coil.
> 5. The harness white wire goes to the "Neg" side of my coil.
SInce your car is a - ground, the white or positive wire should go to the +
side of the coil.
> 6. The "Neg" terminal of the coil goes to the distributor.
This is correct. Neg terminal to the distributor.
> Does this help?
> Alex
On both my 3 and 4 (both + ground), the red wire was converted to a eye
connector and is grounded to the body.
The black wire goes to the white (negative) wire coming off the harness.
Now since I have both + ground cars and Lucas Super coils, which are clearly
marked + and - I assume if you have a - ground car then your ground should be
connected to the - coil terminal.
Now this could be wrong and you should ask a lister who has converted to -
ground in a 3 and uses a coil that is marked + and -.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|